Thingiverse
Ulanzi VL49 light grid
by fezz
12
Downloads
11
Likes
1
Makes
Grid light modifier for Ulanzi VL49 LED light. Should fit other Ulanzi models with the same dimensions.
Print settings are key here. Set the top and bottom solid layers to 0, Infill to Grid and experiment with Infill %. 10% is a good starting point. The rule here is simple: denser infill gives more focused light but at the same time light beam is weaker.
Add brim if bad adhesion is weak.
Print settings are key here. Set the top and bottom solid layers to 0, Infill to Grid and experiment with Infill %. 10% is a good starting point. The rule here is simple: denser infill gives more focused light but at the same time light beam is weaker.
Add brim if bad adhesion is weak.
fezz also publishes on
1 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
