Ultimaker 2 Cover

My printer is in a drafty spot in my workshop so, to cut down on curling corners on the occasional print, I created a simple cover. This cover is designed to hang on the front of the machine to block drafts and can be switched over to the side when you want to access the print bed.

This cover gets laser cut out of 1.5mm acrylic, though it should work just as well with 3mm acrylic. It also requires three copies of the printed peg included in this Thing and three 8mm M3 thread-forming screws (McMaster Part #96817A908). Print the pegs with solid infill and attach them to the acrylic using the thread forming screws. Adjust the lower peg along the slot until the fit works for your machine, tighten everything down, and you're ready to use the cover wit your prints.

**UPDATE** - Based off of a recommendation by Chompworks, I've turned the hole for the lower peg into a fastener so you can fine tune the cover's fit to work on your machine.