Ultimaker 2+ door

This is my Ultimaker 2+ door . Easy to install and disassemble, just pull it up.
You can mount it without modifying the printer Frame, fix it with 3 screws on the left or the right side.

Parts needed:
4mm acrylic glass 270x290mm,
hinge_door: super glue to fix it on the acrylic glass (door_drawing)
hinge_printer: 3x M3 flat head screw 25mm;
Lock:
2 metal springs 16mm x 5mm Diameter
4x M3 cheese head screw 18mm
1x M3 chese head screm 20mm

To install the lock, see the door_drawing file below for the dimensions. Then fix it according to the drawing with a clamp, drill the 4 holes 4mm and attach it to mark the breakthrough.
I made the cut with my dremel.
Then attach the parts lock_lever and lock_outside on the front of the door, screw thew inner bolt part to the lock_lever. Put the metal springs in the provided holes and add the last part lock_inside. You need a screw driver to get the spring in the hole from the lock_inside part.