Thingiverse
Ultimaker 2 filament guide
von vapor83
154
Downloads
116
Likes
1
Makes
This is a modified version of ppyromann's design. Pully is the same but the center shaft is different. It fits the 608 bearing perfectly. You just need a M3x20 screw and M3 lock nut.
If you need bearings, go to a skate shop & ask. They will prob hand you half a dozen "old" 606 bearings for free!
If you need bearings, go to a skate shop & ask. They will prob hand you half a dozen "old" 606 bearings for free!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
