Ultimaker 2 simple front panel

Ultimaker 2 simple front panel and could be stored on the printer side

Requirement:
-Glue (I just used hot glue)
-1.8mm acrylic or plexiglass (325mm x 315mm)

Tip: Hold the acrylic panel in place with masking tape then apply glue to the brackets

This design is inspired by Ultiarjan Ultimaker2 minimalist front panel
https://www.thingiverse.com/thing:581159

- 325mm is the distance between the printer virtual panels
- 315mm is the distance between the front panel screws to the top of the control rotation.