Thingiverse
Ultimaker door locks
von danielkaldheim
1
Downloads
1
Likes
0
Makes
A simple way to create a door for your Ultimaker 3d-printer.
The Plexiglas dimensions for Ultimaker 3 is:
Width: 30cm
Height: 32cm
Thickness: 4mm
Two holes (3mm in diameter) at the bottom is 15 mm from the bottom and 52.5 mm from the sides.
Two holes (8mm in diameter) at the top is 45 mm from the top and 25 mm from the sides
The Plexiglas dimensions for Ultimaker 3 is:
Width: 30cm
Height: 32cm
Thickness: 4mm
Two holes (3mm in diameter) at the bottom is 15 mm from the bottom and 52.5 mm from the sides.
Two holes (8mm in diameter) at the top is 45 mm from the top and 25 mm from the sides
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
