Ultimaker Inspired Cupcake Gantry

This is part one of a redesign of the cupcake using the ultimaker 3-axis setup. It's intended to be backwards-compatible with existing cupcakes, which is to say that you should be able to print out the parts here, modify your cupcake enclosure, and install; more on that in another Thing. The pictures show the arrangement for the cupcake, which should give a reliable build volume of 194mm x 132.5mm x 145mm, or about 2.5 times the build volume in the cupcake with no increase in exterior dimensions. However, using the same printed parts you could scale this to whatever you'd like.

It's also intended to use the Mk5/Mk6 toolhead with a short bowden-style extruder tube and the Gen3/Gen4 electronics (Gen4 strongly suggested).

For this assembly I decided to use threaded inserts for thermoplastic parts instead of the more common through-bolt arrangement; although it increases cost a bit it allows for blind holes, which was important here since space is a very limited.

This is still