Ultimate Desiccant Holder

ULTIMATE DESICCANT HOLDER

I was in need of a desiccant holder awhile back so I looked to Thingiverse, as one does, but couldn't find anything great, so I designed this one. I wanted something that had the most possible air openings, but also printed fast and reliably. A lot of the files I have seen do not adhere to the bed well, or take a very long time to print. This guy will print quickly and reliably.

Sizing Notes:
-As is, I was able to achieve a nice snap fit when printed on my Creality CR-10s, and on an Ultimaker 3, but of course snap fits are not the easiest
-> If you are having trouble with fitting, I recommend scaling the lid up or down just a little bit, and that should do the trick, don't waste your time sanding it

The 40D version fits great inside the center of most spools, the 50D version is much larger and good for putting in tubs and what not, I use a few of the 50D 80H holders in my big airtight containers.