Ultimate Nozzle Wiper Enhanced version

The Ultimate Nozzle Wiper is a fantastic idea. After replacing it, I no longer have to manually clean the nozzle. However, it has a flaw. I printed it using PETG material, and after half a month of use, it broke.I tried changing the printing surface, but the bottom broke even faster. Ultimate Nozzle Wiper是一个非常棒的想法，更换了这个后，我再也不用手动清洁喷嘴了。但它有个缺陷，我使用PETG打印，在使用了半个月后，它断了。我尝试了更换打印面，但底部断裂的更快。In the end, I created this version, which is exceptionally sturdy. I used screws from a discarded notebook, 1.45mm * 4.2mm in size. After screwing them in from the bottom, I couldn't even break it by hand. I believe this can withstand the impact of the nozzle. 最后，我制作了这个版本，它异常坚固。我使用淘汰笔记本上的螺丝，1.45*4.2，从底部拧入后，我尝试用手都无法掰断，我相信这个可以承受住喷嘴的撞击。The length of the screws should ideally be between 4mm and 13mm; if too short, they won't provide any reinforcement. Please note that after screwing in the screws, there should be no protrusions at the bottom. 螺丝的长度尽量在4mm-13mm，太短起不到任何加固的作用。请注意，拧上螺丝后，底部不要有任何凸起。 I also attempted to