Ultra Basic Shower Curtain Rod Holder

That shower curtain rod fell down once too often, so here we go.

Specs:

- Max shower rod diameter for this one: 34mm (mine was 33mm). Up to 30% smaller should be fine and still look good.
- Total dimensions: 72mm diameter, 20mm depth, 2mm thickness everywhere (so surface for shower rod to lay on is 18mm deep).
- To attach you need 2 screws, 7mm diameter screw heads, 3mm diameter screws (spec'd as 3,0 x 20 mm on the box). I used 5mm wall anchors from the same box, and used a 5mm drill bit. Screws get perfectly sunk.
- Distance between the screw holes: 18mm (one center screw and one to the top).
- Or just open it up in Blender and select the vertex loops and use scale tool to adjust to whatever screws you have around and where you want them.
- Most shower curtain rods have two ends, so you usually need two of them. You can just load the STL twice into Cura if you want. Just make sure both are on the buildplate with their flat side if you want to print without support.

Print settings: