Ultra Fine Sharpie Holder

This is a simple holder to hold 8 ultra-fine point Sharpies. It may work for other markers as well with a little scaling. Given my printer's "tolerances", the markers are held in nicely by friction. If you want to test the fit, print just the top by moving the whole thing down in your slicer so most of the model is embedded in your print bed.

I printed it opening-side-up with the longer dimension in-line with my bed traversal (less likely to detach from the bed). No infill is needed. There's hardly any empty space to begin with, the infill just slows it down. I added one extra top layer to compensate, but that was probably unnecessary.

Designed in Fusion 360 during a Zoom meeting instead of doodling on paper.