Ultra Flat Filamentholder

##Ultra Flat Filamentholder##

I redid my old Flat Filament Spool Holder in Autodesk Fusion 360 (completely free for private and small business -users) and made it 8mm lower. Improved accuracy, print time, and did a general touch up.

You can view it in 3D on Autodesk360 hub.
Hope you like it.

##Usage##
Mount on the rear/side or inside your printer case...On your wall or in cabinets etc etc.
The numbers in the filenames are indicates how many times you need that specific part printed.

##Extras##
I've added some Slider Mounts Extender and Slider Mounts Short Extender in case you have special needs.
I use the extender parts to be able to use big 2.3kg rolls, but also use the same setup for smaller standard rolls.

##BOM##
6x F688 bearings - METRIC: 8mm (Inner) x 16mm (Outer) x 5mm (Width)
2x m3 lock nuts - nylon.
2x m3 heat set or press fit nuts
4x m3 20mm screws
+ screws/nuts to mount the parts to the surface of your choice