Thingiverse
Ultrabatic Slope Glider - Version 2 !!!
von FreeFlight
1.1k
Downloads
791
Likes
3
Makes
UPDATE: 28/05/2020 - After one season flight with prosand cons i designed the upgrade for my model. A new fuselage with better CG (no lead required) and less prone to break. Revision 2 of fuselage uses the same wings and tail of previous rev so you don't have to re-print everything. See zip file for the STLs and last photo for comparison with revision 1. Major chages are:
1) increased lenght of the front section for correct CG without lead
2) reduced lenght for tail section for right CG
3) new canopy with magnetic lock
4) cables are straightened for better installation
5) addeed three balsa spar in the rear fuselage to avoid breaking
6) designed to be printed with a max H of 160mm (received a lot of request)
Not yet maidened due to Covid but hope soon.
If you want to send me a tip I can continue developing new models.
UPDATES: 14/06/2019 - added some photos of the tail with linkage installed. This is my solution to make tail removable
UPDATES: 07/06/2019 There is a repor
1) increased lenght of the front section for correct CG without lead
2) reduced lenght for tail section for right CG
3) new canopy with magnetic lock
4) cables are straightened for better installation
5) addeed three balsa spar in the rear fuselage to avoid breaking
6) designed to be printed with a max H of 160mm (received a lot of request)
Not yet maidened due to Covid but hope soon.
If you want to send me a tip I can continue developing new models.
UPDATES: 14/06/2019 - added some photos of the tail with linkage installed. This is my solution to make tail removable
UPDATES: 07/06/2019 There is a repor
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
