Thingiverse
Umbrella bowl
by Oana
6
Downloads
8
Likes
0
Makes
Umbrella bowl.
You will also need a 3mm skewer for the shaft. I found these skewers vary in size so the fit might not be quite snug.
I mainly made these to hold the crystals from the board game Unicorn Glitterluck so my kids didn't lose them while we were playing. You can do one in each colour for each unicorn. For Unicorn Glitterluck I used a little bluetac at the bottom of each plastic piece. It holds everything in really well if the skewer is loose but is still removable so you can take the handle off to be able to pack it into the box when not in use.
You probably want to put some supports under the handle, the bowl doesn't need any.
You will also need a 3mm skewer for the shaft. I found these skewers vary in size so the fit might not be quite snug.
I mainly made these to hold the crystals from the board game Unicorn Glitterluck so my kids didn't lose them while we were playing. You can do one in each colour for each unicorn. For Unicorn Glitterluck I used a little bluetac at the bottom of each plastic piece. It holds everything in really well if the skewer is loose but is still removable so you can take the handle off to be able to pack it into the box when not in use.
You probably want to put some supports under the handle, the bowl doesn't need any.
Oana also publishes on
6 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
