Thingiverse
Umbrella handle
von PatientPrinter
2
Downloads
0
Likes
0
Makes
This is a basic umbrella handle. It ahs to be screwed to the umbrella. This thing does not have planned for it so I screwed it by force and it works.
The uploaded version is a sligtly different one than the printed one :
> on the picture with the red arrow, the pin is just removed. The target is to be able to hold the ribs and tips "into" the handle, to keep the umbrella closed.
I did make 2 STL (see the 2 screenshots from Freecad), the final one and also a "test" one, to see if your umbrella can be screwed. To print it, you can give him a negative position in Cura, not to print it completely and save some time.
> the freecad file does include the hanlde and the test.
The uploaded version is a sligtly different one than the printed one :
> on the picture with the red arrow, the pin is just removed. The target is to be able to hold the ribs and tips "into" the handle, to keep the umbrella closed.
I did make 2 STL (see the 2 screenshots from Freecad), the final one and also a "test" one, to see if your umbrella can be screwed. To print it, you can give him a negative position in Cura, not to print it completely and save some time.
> the freecad file does include the hanlde and the test.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
