Umbreon - Pokemon - Hueforge

If you resize the model make sure you do not scale the Z axis or the print colors will not be in the same position Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size You may print at higher layer heights below the Min Depth of 0.48mm The Max Depth is 2.2mm and the Actual Depth is 2.2mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Basic Yellow Transmission Distance: 6 PLA BambuLab Basic Jade White Transmission Distance: 5 Swap Instructions: Start with Black At layer #7 (0.64mm) swap to Red At layer #9 (0.8mm) swap to Yellow At layer #16 (1.36mm) swap to Jade White for the rest. Disclaimer: This model was created with the assistance of AI tools.