UMX Timber Wall Mount

This is a wall hanger for the tail wheel on the Horizon Hobby UMX Timber. I designed it so that the rear wheel is held while allowing the wire to slide through. Add some double sided sticky tape (i used double sided sticky foam in the pictures from walmart), holds great and no holes in your wall.

I printed mine at 100% infill as the walls are only 2mm thick, even with 100% infill the print time was only just over an hour at 15 grams weight. An infill of about 20-30% should work too as the UMX Timber is very light.

Requires support, Printed as shown in images with the portion of the hanger that sticks to the wall flat on the bed.