UNAS 2 Wall Mount

#### Description

This is a simple wall mount for the Ubiquiti UNAS 2 storage device. The unit itself is powered via PoE+++ so it doesn't need a power brick, and the supply and drives load from the bottom. I personally prefer to mount what I can to walls and keep things up and out of the way of the kids, so I wanted a mount that would let me do just that.

The design has three cabling holes plus the front is open to allow use of the USB-C connection. One hole on the rear left and right, and one at the bottom where the ethernet jack is located.

This print can be made pretty easily flat on the bed or standing up on its back depending on your needs. If you print it lying flat on the bed, no supports are required.

#### Suggested Settings

* Layer Height: 0.2mm
* Infill: 13-15%
* Pattern: Cubic
* Gap Fill: Everywhere
* Supports:
* Lying Flat: None
* On Back: Tree support suggested
* Mounting Screws: Any 4.4mm screw or bolt. The hole is counter sunk so the head can lay flat.