Thingiverse
Under Chassis SD Card Mount
von Jueda
4
Downloads
1
Likes
0
Makes
I created this to fit with the **Mini SD Card Holder Insert** that can be found here: https://www.thingiverse.com/thing:3136898
This part fit's snug with each other and will not fall out and can be mounted anywhere on your printer that you wish.
The holes are **3mm**, you may use a drill bit to make the holes bigger if needed.
***Note:*** *Since the part is a tight fit, you will have to make sure that they are lined up and level with one another as you press it into one another.*
This part fit's snug with each other and will not fall out and can be mounted anywhere on your printer that you wish.
The holes are **3mm**, you may use a drill bit to make the holes bigger if needed.
***Note:*** *Since the part is a tight fit, you will have to make sure that they are lined up and level with one another as you press it into one another.*
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
