Thingiverse
Under Desk Cable Management Clip
1
Download
2
Likes
0
Makes
Nothing super earth shattering here. Just my take on some under desk cable management clips.
They are open ended with an angle so that the wires wont drop out. All edges are chamfered so that supports will be minimal or not needed.
Printed these laying flat on the base as shown in the image, no supports. It took about 40 minutes. I use Anycubic's ABS like water wash resin as well.
They were designed to be printed 2" high but can scale up easily.
They are open ended with an angle so that the wires wont drop out. All edges are chamfered so that supports will be minimal or not needed.
Printed these laying flat on the base as shown in the image, no supports. It took about 40 minutes. I use Anycubic's ABS like water wash resin as well.
They were designed to be printed 2" high but can scale up easily.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!