Under Desk Caliper Storage

This is a re-mix of jsmith14's Caliper Holder.

I split it in half so it could be printed on the 220mm x 220mm bed of my SV06. I added alignment pins and holes so that it could be properly lined up for mounting/gluing. I also added additional mounting bosses as I didn't want to depend on the strength of the pins/glue to hold the two halves together when mounted. I would recommend gluing the two halves together before mounting, but if you are careful you can skip the glue.

I also removed the magnet mounting locations as I had no need or plan to use them.