Under Desk Drawer

This is a simple under desk drawer that can be attached either with glue or screws. You will need to glue the stopper on the underside of the drawer to prevent it falling out (we did it this way to improve print speed and reduce support use) to do this put the drawer in the support bracket, then in the closed position, glue the small stopper to the bottom of the drawer at the rear in the large gap provided in the runner. Once installed on the desk, the drawer will not fall out. You can attach some 7mm magnets to the back of the drawer to aid closing. To attach the magnets to the support bracket, first install them in the drawer, let the glue set, then put the oposite magnets on the drawer magnets, apply glue to the back of the magnets, then close the drawer and let the glue set.