Under Desk Drawer

This was designed to tidy up some desk clutter. The housing structure is rather material intensive and it also needs support during printing, so that might be worth looking at to investigate possible improvements. The printed version shown here needed the holes drilling out and countersinking to accept the four 100 x 6 woodscrews required for under desk mounting, but the STL file has now been modified, so hopefully the clearance for 6mm screws will be ok.
The drawer and handle don't need support during printing.
There is a hole to accept a short self tapping screw to stop the drawer sliding out too far.
The handle is an experimental design to see if it would clip to the drawer. It seems to be OK, but if it works loose it will just need a blob of glue.