Under-Desk Mount for Artika Light Controller

I was tired of my Artika controller sliding around and snagging cables, so I printed this little under-table bracket. Two tiny screws, slide the controller in, done. It tucks the box up out of sight but you can still reach the buttons and route the wires straight out the ends—no weird bends.Inside clearance is sized for controllers ≤17 mm tall and ≤42 mm wide (measure yours). I made the fit a bit snug so it doesn’t rattle. Prints flat on the bed—no supports. I used ~20% infill in PLA; PETG is fine if your desk area gets warm.Reccomend printing with supports or cutting it in half