Under-shelf C-Mount Microscope Mount and Slider

There's a lotta parts to print here so let's start with the fact that if you're in a metric country, you'll want to adjust fastener sizes in the PARAMS spreadsheet in the freecad file.

You're gonna need a bunch of 1/4in hardware:
Nuts - 4
Wing nut - 3
Hex head bolts:
1 at 2.5in
1 at 2in
4 at 1.5 in

Then you'll need some 3/4 in thin walled pipe. I used aluminum deck pickets, but copper pipe should be fine. This is 19mm for you metric folks. This can also be adjusted in the PARAMS spreadsheet if you can't get what you need.

The part called topslider should be printed upright for maximum strength. You need to press a nut into the square slot and put a bolt through it for bracing against the shelf. Make sure to install the bolt and knob in the centre before final assembly of the rails!


The part called central bracket should be printed with its largest face flat on the platform. Install the 2 hex head bolts and knobs before assembling onto the rails.


The endcaps(you