Underdesk cable holder

This is a underdesk cable holder out of 2 pieces, but prints from one file.

Max. cable diameter 7mm.
If 2nd piece is left away / flipped around, it reduces to 3.5mm / 2x 3.5mm.

Width for cables is 40mm.

Standard flathead wood screws to be used: 3.5x30mm to 4x30mm for both pieces used and 20mm desk plate.

Use 2nd file to print a gauge for placement of pre-drilled holes (2.6mm).
Distance will be 60mm from edge of the desk plate.


Hope you like it!
Best regards from
Bernd's Custom 3D's.