Unfolded Circle Remote 3 Stand

A charging stand for the Unfolded Circle Remote 3. The stand has a hole for a wireless charging pad, I used a couple of cheap chargers from Amazon that are 56mm in diameter. Supposedly the Apple MagSafe charger is also 56mm, but I don't have one so cannot verify. I recommend putting some thick tape (I used electrical tape), or something similar on the side of the wireless charger to make up for any variances and help it fit better. Alternatively you could glue it in or use double sided tape, but press-fit was enough for me. The model should print in-place without any support and default settings, but my print profile includes some tweaks to assist with some of the curve outs (slower print speed, variable layer height, increased cooling, and cooler print temp) and a support for the top of the charging pad circle, these tweaks increase print time, but improve the quality IMO.