Uniformation D265 Curing Machine Driver Conversion

So my DC-DC converter in my Curing machine went bad, It was a really lazy design in the first place no Constant Current Driver for the LED's and the turntable motor was on the same DC-DC buck. So I decided to get a constant current/constant voltage driver and split them into separate circuits. As far as I can tell these are 1W LED's with a current rating of 350ma, four parallel string I know its a bad idea but I am too lazy to install 4 independent drivers and set the current at 1.2A so if one goes out it will only hit 400ma and should be fine for a short time. But I used and designed this to use https://www.amazon.com/dp/B0F42P23FZ?ref=fed_asin_title off amazon for the drivers and I put a tapered hole in the middle to attach them with hotglue to act as an anchor because hotglue doesnt stick really well to my filament. I suggest PETG or ABS but PLA might be fine. Fits into the pegs nicely. I also set the Voltage for the Turntable at 8V and it was originally at ~13.5V originally