Thingiverse
Engineering
Go to Model
Universal Microscope Phone Adapter iPhone XS Plus
7
Downloads
8
Likes
0
Makes
I extended the Slide_Left_Center_Logo file by 20mm so that my iPhone XS Plus with case would fit. Thanks Arsenal for a great design!
This information is from Arsenal's original design:
Parts List:
Qty 6: 4-40 x 1/2 Socket Head Cap Screw (McMaster 92196A110)
Qty 1: 2.5" x 1/4" OD Spring (McMaster 9657K171)
Qty 1: 1/4" x 1-3/8" Clevis Pin (McMaster 97245A242)
Qty 1: 1/16" Cotter Pin (McMaster 98335A044)
Qty 1: .56" Dia x .063" wire x 120 deg Torsion Spring (McMaster 9271K641)
1) Screw the left cap onto the left slide and the right cap onto the right slide. It really helps to start the screws a few turns in each of the holes first then take them back out and assemble the two parts.
2) The recess down the center of the right slide has to fit over the square piece of material underneath the left slide. After the right slide is over the square piece of material the two pieces can slide together.
3) Feed the spring through the hole in the bottom of the right sli
This information is from Arsenal's original design:
Parts List:
Qty 6: 4-40 x 1/2 Socket Head Cap Screw (McMaster 92196A110)
Qty 1: 2.5" x 1/4" OD Spring (McMaster 9657K171)
Qty 1: 1/4" x 1-3/8" Clevis Pin (McMaster 97245A242)
Qty 1: 1/16" Cotter Pin (McMaster 98335A044)
Qty 1: .56" Dia x .063" wire x 120 deg Torsion Spring (McMaster 9271K641)
1) Screw the left cap onto the left slide and the right cap onto the right slide. It really helps to start the screws a few turns in each of the holes first then take them back out and assemble the two parts.
2) The recess down the center of the right slide has to fit over the square piece of material underneath the left slide. After the right slide is over the square piece of material the two pieces can slide together.
3) Feed the spring through the hole in the bottom of the right sli
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
