Universal Multiboard Clip Mount (w/.step files)

This is a two part design that I made to allow me to mount nearly anything to the face of a Multiboard tile. Part A gets combined into whatever you want to mount using the combine function in Fusion 360. It has a slot for a captive M3 nut but it also works if you remove the slot and make the hole in part A slightly smaller so that you can screw directly into the plastic instead of using a nut. Part B is the screw on latch that gets fastened to part A with an M3*8mm screw. The whole assembly then snaps onto the Multiboard as shown in the photos. All of the things mounted on the Multiboard in the photos have been mounted using this mount.You can use as many or as few mounts as your model requires and you can stack them vertically or horizontally 25mm apart to match the Multiboard large hole spacing. Requirements:You need a 4 to 5mm gap between the back of the tile and the wall (2mm for the print itself + screw head height).One M3*8mm screw + M3 nut per mount (you can also remove the capt