Thingiverse
Universal Phone Stand (Parametric)
von Gythral
11
Downloads
8
Likes
0
Makes
The original I found a little too low for the charger plug & a little bit to short overall for my new phone, so I thought I would redo it in OpenSCAD so that the height for the charger plug, the over all height, width, phone support width and lean could all be changed to suit any phone or tablet
In all the photos the smaller stand is the original design, the larger my version (and there is not a phone on either due to screen reflection)
In all the photos the smaller stand is the original design, the larger my version (and there is not a phone on either due to screen reflection)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
