Universal Remote and Controller Holder V4

Do you have a side table? Do all your remote have a width of less than 55mm? Do you have Xbox style controllers, or even perhaps, a steam controller? If you answered yes to any of these questions, I have the design of the century for you.

This is a universal remote holder. Universal in the sense that I took all the remotes in my apartment that I could find, measured them, found the widest one, and then made each compartment that plus 5mm. This can fit three remotes comfortably, as well as two Xbox style controllers. This does not work with PS4 controllers, I could design something that does, but only if there's an interest in it. This uses a single #8 x 1-3/4" construction screw. The design in the IRL pictures is also one customized for my specific remotes, the files I uploaded has the same remote compartment width for each one and is universal.

Anyway, I've included pre-sliced STL files with supports. For the controller holder parts, I used Meshmixer tree supports. Use wire cutt