Universal Skateboard wall-mount

This is a part designed to enable one to mount a generic skateboard to a wall while exposing the underside of the deck to be viewed. It mounts directly to the board where the trucks would normally be mounted and should be installed on the upper half of the board. It is important to note the distance between the top-most parts of the board and the center of the truck-mount area. If that distance exceeds 45mm (1.77 inches), this mount will not work. In other words, if the distance between the wall and the middle of the board is greater than the previously listed measurements, then you will have to "stretch" the part in a slicer file. Do not scale up the part as the bolt holes will no longer line up with the board. The holes in this part have proven in testing to be the perfect size to screw in the bolts that were used, essentially threading the part as the bolts were screwed in. It is advised for reliability and stability to install nuts onto the ends of the bolts. They work best on Herc