Thingiverse
Universal Spool Holder
von Procomz
1
Downloads
0
Likes
1
Makes
This spool holder can accomodate almost any spool.
To build it, you will need :
- 4 * 608ZZ bearings
- 2 * 15 cm of M8 rod
- 2 * 15 cm of M4 or M5 rod
- some nuts and washers corresponding to the rods.
You will also need to print :
- 2 * body.stl
- 1 * body_bottom.stl
- 2 * rotor.stl
To build it, you will need :
- 4 * 608ZZ bearings
- 2 * 15 cm of M8 rod
- 2 * 15 cm of M4 or M5 rod
- some nuts and washers corresponding to the rods.
You will also need to print :
- 2 * body.stl
- 1 * body_bottom.stl
- 2 * rotor.stl
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
