Thingiverse
Universal Ultimaker 2(+) Spool Holder
par Undeviljur
1.8k
Téléchargements
1.6k
Likes
23
Makes
Now updated to V2. (changelog below)
This is a universal Spool Holder for the Ultimaker 2(+) and is easy detachable while holding a spool. This makes it easy for people who don't have good access to the back of their printer.
The Spool Holder can hold spools with an inside diameter from 39mm up to 70mm and a maximum width between 95mm and 125mm (depending on the inside diameter).
Technical information:
The tread used to clamp the spool is a multi pitch thread (multiple starts, like a jar of jam) so the travel per revolution is 3 times as much. This makes putting on the nut easier and you don't have to make as much revolutions to clamp the spool.
Make one of every part except for the "Plastic Bearing" you need to of those.
You also need:
- M8 threaded rod 150mm long.
- 2x M8 nuts to assemble.
- If possible I recommend Tread locker (LOCTITE) on the nuts.
Changelog Update V2: I made the tolerances bigger so there should be no more problems with parts that don't fit
This is a universal Spool Holder for the Ultimaker 2(+) and is easy detachable while holding a spool. This makes it easy for people who don't have good access to the back of their printer.
The Spool Holder can hold spools with an inside diameter from 39mm up to 70mm and a maximum width between 95mm and 125mm (depending on the inside diameter).
Technical information:
The tread used to clamp the spool is a multi pitch thread (multiple starts, like a jar of jam) so the travel per revolution is 3 times as much. This makes putting on the nut easier and you don't have to make as much revolutions to clamp the spool.
Make one of every part except for the "Plastic Bearing" you need to of those.
You also need:
- M8 threaded rod 150mm long.
- 2x M8 nuts to assemble.
- If possible I recommend Tread locker (LOCTITE) on the nuts.
Changelog Update V2: I made the tolerances bigger so there should be no more problems with parts that don't fit
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
