Thingiverse
Uno card box
von Redfeatherr
10
Downloads
6
Likes
0
Makes
The box of my UNO cards has seen its better days, so I decided to 3D print a solution.
This is designed for the standard 108 card deck. If you have a larger deck, you may have to scale it up.
I printed this design upright, using Cura's tree supports for the top overhang, just so it's easier to remove. The lid obviously needs no supports
5% infill should be enough, though I used 15 for rigidity.
The lid is friction fit, you may have to scale it by +-0.1 mm depending on how it fits.
This is designed for the standard 108 card deck. If you have a larger deck, you may have to scale it up.
I printed this design upright, using Cura's tree supports for the top overhang, just so it's easier to remove. The lid obviously needs no supports
5% infill should be enough, though I used 15 for rigidity.
The lid is friction fit, you may have to scale it by +-0.1 mm depending on how it fits.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
