Thingiverse
Uno case (Arduino)
von ChArlie_24
89
Downloads
83
Likes
0
Makes
I give you.......(pause for dramatic effect)........ the WWYS case.
Must be printed at 0.2mm layer hieght and with bridge settings 'ON' to achieve the mesh look on top of the USB connector.
Must be printed at 0.2mm layer hieght and with bridge settings 'ON' to achieve the mesh look on top of the USB connector.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
