UPDATED E3D Direct Drive Bracket for Flashforge Creator Pro

UPDATED VERSION

This one gives a bit more room for the fan and allows the heater block wires to come out the back and not get pinched.

This will allow you to use a E3D V6 and Titan extruder on your FFCP ( NOT TESTED ON OTHER MACHINES)

Used a pancake stepper motor as a standard one hits the back of the machine but you can tape a block on the left Y carriage to hit the end stop if you want.

In S3D set your offsets to 7.50 and -7.50 as per the picture.

Up your extraction rates by about x3.3 I use 3.60-3.70 for ABS now

Remember to either wire the new motor so it turns the other way or set that in the firmware with RelicatorG

Feed the heater and thermo wired through the hole on the left then use a cable tie to hold them in place.

The clip goes on first at the back to stop the block moving, put the 2 small spacers (PEG) in the gaps on the carriage and place the mount on top. ( I stuck my spacers on) I also printed 2 more to act as washers/clamps on the top.