Thingiverse
(UPDATED) Ender 3 V3 SE Vent Ring
by Geclite
199
Downloads
461
Likes
3
Makes
(UPDATED)
Re-made the ring from scratch.
1 - Fixed the gap issue between the fan and ring.
2 - Now has 3 more vents than the original, with much less back flow through the fan (still a little, but not bad).
3 - Vents now push air straight out and down.
4 - Increased the overall volume inside.
This is a now re-imagined Vent ring from _3DDP_ that fits an Ender 3 V3 SE. Must be paired with Sand's lightweight fan shroud found on Printables.
https://www.printables.com/model/637754-ender-3-v3-se-lightweight-fan-shroud
May also work with Muganon's Fan shroud. UNTESTED
Re-made the ring from scratch.
1 - Fixed the gap issue between the fan and ring.
2 - Now has 3 more vents than the original, with much less back flow through the fan (still a little, but not bad).
3 - Vents now push air straight out and down.
4 - Increased the overall volume inside.
This is a now re-imagined Vent ring from _3DDP_ that fits an Ender 3 V3 SE. Must be paired with Sand's lightweight fan shroud found on Printables.
https://www.printables.com/model/637754-ender-3-v3-se-lightweight-fan-shroud
May also work with Muganon's Fan shroud. UNTESTED
Geclite also publishes on
1 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
