Updated LED and Push button for the spotwelder case by ChrisvK here https://www.thingiverse.com/thing:4617677

This is an update for newer versions of the spot welder that Crhis made a case for here:
https://www.thingiverse.com/thing:4617677
This allows for the new flat push button.
For the LED light pipe I made a square guide that goes over the LED and has a hoel in it 1.75mm in diameter. Simply cut a length of clear filiment and run it through this to just above the LED and then vut it off just above the case lid. This allows the light to be transmitted through the filament a lot better than a printed version (as the light is diffused at every layer)