Thingiverse
UPGRADE Raspberry Pi 7 Inch Touchscreen Case
von ImmenseFiend
31
Downloads
14
Likes
0
Makes
This is my take on pimping out this raspberry pi case. It's got heat sinks, a 5v fan, and my fiber optic indicator light design.
If you are going to print this, you will still need the file called "Raspi7inch_Front.stl" from the original. If you don't plan on using the fiber optic indicator lights, you can use the "Raspi7inch_Case.stl" from the original as well. Basically, the only difference between my remix of the case and the original is that mine is slightly taller to accommodate the fiber optic indicator mounts and I made the side ports (USB-C, HDMI, etc) a bit easier to get into.
2020 mounts that I used:
https://www.thingiverse.com/thing:4561701
Piber Optic indicator system:
https://www.thingiverse.com/thing:4843174
If you are going to print this, you will still need the file called "Raspi7inch_Front.stl" from the original. If you don't plan on using the fiber optic indicator lights, you can use the "Raspi7inch_Case.stl" from the original as well. Basically, the only difference between my remix of the case and the original is that mine is slightly taller to accommodate the fiber optic indicator mounts and I made the side ports (USB-C, HDMI, etc) a bit easier to get into.
2020 mounts that I used:
https://www.thingiverse.com/thing:4561701
Piber Optic indicator system:
https://www.thingiverse.com/thing:4843174
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
