Thingiverse
Upside Down Flask Holder
von creativspelerr
36
Downloads
26
Likes
1
Makes
This holds an erlenmeyer flask upside down.
The intent is so that a stoppered flask can be put upside down while a mix of two liquids separates by weight, then the bottom heavier liquid can be drained off. I use a two hole stopper and 1/4 inch vinyl tubing. One tube goes all the way up to the air space at the "bottom" of the inverted flask and allows air in as the liquid drains. The other tube is short and is the outlet for the liquid. The "8" shaped part is a clamp that allows the short tube to be crimped closed.
It's designed for a 125mL flask, but can be scaled for other sizes.
It could also be used as a drying rack.
The intent is so that a stoppered flask can be put upside down while a mix of two liquids separates by weight, then the bottom heavier liquid can be drained off. I use a two hole stopper and 1/4 inch vinyl tubing. One tube goes all the way up to the air space at the "bottom" of the inverted flask and allows air in as the liquid drains. The other tube is short and is the outlet for the liquid. The "8" shaped part is a clamp that allows the short tube to be crimped closed.
It's designed for a 125mL flask, but can be scaled for other sizes.
It could also be used as a drying rack.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
