Thingiverse
Ural motorcycles Keyring
von glaca21
9
Downloads
7
Likes
0
Makes
This is Ural motorcycles logo keyring I do not take credid for this keyring, I only created this key ring using photo of the ural logo.
It will depend on your printer, software and material, whether you decide to use supports and rafts. it is possible to print without any raft or support but its challenging however this is up to you to decide I do not take any responsibility for the way you print this or any of my files.
main bits to know:
no supports or rafts
210*C PLA
no bed heating required
20% infill (but you can add or reduce the infill depending on your pring quality and skills)
speed - extruding 60mm/s, travel 150mm/s
about 30min to 1hr print time required
using software - Solidworks to build and Makerbot software for STL file
I do not take credit for anything. This project was made just to see if It’s possible to make something like a cool looking keyring using my skills.
Thank you any questions feel free to ask.
It will depend on your printer, software and material, whether you decide to use supports and rafts. it is possible to print without any raft or support but its challenging however this is up to you to decide I do not take any responsibility for the way you print this or any of my files.
main bits to know:
no supports or rafts
210*C PLA
no bed heating required
20% infill (but you can add or reduce the infill depending on your pring quality and skills)
speed - extruding 60mm/s, travel 150mm/s
about 30min to 1hr print time required
using software - Solidworks to build and Makerbot software for STL file
I do not take credit for anything. This project was made just to see if It’s possible to make something like a cool looking keyring using my skills.
Thank you any questions feel free to ask.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!