Thingiverse
URUAV TMX5 Multi-Protocol Module extended antenna mount v2
von Arkimedes64
2
Downloads
4
Likes
0
Makes
URUAV TMX5 4 IN 1 Multi-Protocol Transmitter Module cover.
As the original cover doesn't allow to have antenna in vertical orientation on some transmitters, I made extended version.
(Transmitter in photos is Taranis X9D)
No soldering or modification needed, except small hole at the bottom of the module.
If you don't want to make a hole in your original case, print new one.
Otherwise it's easy swap.
The two parts screw together and I recommend using nylon or plastic screws to avoid interferrence, but it's not critial as the original design also uses metal screws.
The antena part can be printed verticaly without any supports but add BRIM arround it when printing in this orientation.
As the original cover doesn't allow to have antenna in vertical orientation on some transmitters, I made extended version.
(Transmitter in photos is Taranis X9D)
No soldering or modification needed, except small hole at the bottom of the module.
If you don't want to make a hole in your original case, print new one.
Otherwise it's easy swap.
The two parts screw together and I recommend using nylon or plastic screws to avoid interferrence, but it's not critial as the original design also uses metal screws.
The antena part can be printed verticaly without any supports but add BRIM arround it when printing in this orientation.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
