Thingiverse
USB 7-Port Fast Charge Bracket
by b1ut0
17
Downloads
8
Likes
1
Makes
I bought a Bolse 60W/12-Amp 7-Port USB Fast Charge Station and it was taking up too much room on my desk.
I had previously created this bracket -- http://www.thingiverse.com/thing:517021 for a different device.
Thanks to the magic of openSCAD and parameterization, I only had to change four variables to print out the bracket to fit this new application. It worked on the first try. I had to change the height, width, and length to match the USB charger. Because this device is much smaller than the previous design, I also had to reduce the corner radius from 3 to 1.5 to deal with the smaller dimensions.
http://www.amazon.com/Charging-Desktop-Station-SmartIC-Technology/dp/B00L2SBZ80
I had previously created this bracket -- http://www.thingiverse.com/thing:517021 for a different device.
Thanks to the magic of openSCAD and parameterization, I only had to change four variables to print out the bracket to fit this new application. It worked on the first try. I had to change the height, width, and length to match the USB charger. Because this device is much smaller than the previous design, I also had to reduce the corner radius from 3 to 1.5 to deal with the smaller dimensions.
http://www.amazon.com/Charging-Desktop-Station-SmartIC-Technology/dp/B00L2SBZ80
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
