Thingiverse
usb-c to XT60 adapter (pd trigger)
door tru1337
20
Downloads
13
Likes
0
Makes
Works great with both amass female and male XT-60 connectors.
Printed in PETG with 0.2 layer height.
This adapter (holder/enclosure) uses CTP9 fast charge trigger, which shown in the photos and could be found [here](https://aliexpress.ru/item/1005004642748958.html).
Assembly steps:
1. Turn XT60 pins as it is shown in the photos.
2. Put XT60 and trigger board inside bottom piece (no USB-C hole) and solder it together right inside of the bottom piece.
3. Snap upper piece on bottom piece while leaning upper piece against one of bottom's edge.
Printed in PETG with 0.2 layer height.
This adapter (holder/enclosure) uses CTP9 fast charge trigger, which shown in the photos and could be found [here](https://aliexpress.ru/item/1005004642748958.html).
Assembly steps:
1. Turn XT60 pins as it is shown in the photos.
2. Put XT60 and trigger board inside bottom piece (no USB-C hole) and solder it together right inside of the bottom piece.
3. Snap upper piece on bottom piece while leaning upper piece against one of bottom's edge.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
