MakerWorld
Office
Go to Model
USB Cable Holder
223
Downloads
57
Likes
131
Makes
A USB cable holder. It's in extra draft quality so you will see lines but I just wanted something that was quick to print - I didn't need it perfect looking. I also wanted something that held the end of the USB cable so that I could see if it was usb c or micro usb etc and I achieved this with the little cutout at the front. There are 6 slots that are of equal size and the end one is slightly smaller as I had a very short cable so didn't need it to be as wide. Printing time is 1 hour 40 mins on a P1S 0.4 nozzle is basic PLA. 20cm wide x 7cm deep x 6cm high Hope you find it useful.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
