USB Cable Reel
von yudieg
94
Downloads
79
Likes
1
Makes
This is a USB cable reel to tidy up USB cable in a easy to roll in/out compartment.
This can hold up to 10 ft long cable. It has slot for small apple charger.
This winder has 2 parts which connected by clip mechanism inside the winder. It's easy to clip both together but it's a bit tricky to open once it clipped together. You can pry it with a putty but be careful not to break the top part. I recommend to not keep switching the cable.
To setup the cable, simply insert the cable about 2 inch of the USB connector to the small opening on the inside part. Wind the cable following the direction or the cylinder then insert the other end of the cable to the outside part before joining these part together.
This can hold up to 10 ft long cable. It has slot for small apple charger.
This winder has 2 parts which connected by clip mechanism inside the winder. It's easy to clip both together but it's a bit tricky to open once it clipped together. You can pry it with a putty but be careful not to break the top part. I recommend to not keep switching the cable.
To setup the cable, simply insert the cable about 2 inch of the USB connector to the small opening on the inside part. Wind the cable following the direction or the cylinder then insert the other end of the cable to the outside part before joining these part together.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!