Thingiverse
Hobby
Go to Model
USB Cable Wire Cover
402
Downloads
398
Likes
0
Makes
This is a usb type a cable end.
Few days ago I pulled the cable a bit hard and wires break off from USB port.
In order for me to solder the wires back I needed to cut the cover with hot knife.
After soldering I created this model to cover the connections back because the original cover was melted.
The cable diameter is 3mm. (Radius 1.5mm hole)
Use a drop of **CA GLUE** to bond two halves together.
Few days ago I pulled the cable a bit hard and wires break off from USB port.
In order for me to solder the wires back I needed to cut the cover with hot knife.
After soldering I created this model to cover the connections back because the original cover was melted.
The cable diameter is 3mm. (Radius 1.5mm hole)
Use a drop of **CA GLUE** to bond two halves together.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
