Thingiverse
USB Desk Mount
por ghtharant
8
Descargas
3
Likes
0
Makes
I had the USB extension lying around but I am 95% sure that it is [this Monoprice item.](https://www.monoprice.com/product?p_id=5432)
I printed mine in PETG only because it was already loaded in the printer. PLA would be fine as well. I included 2 files, one with just the bare model which should print just fine. You could probably print it with or without supports (just might be a bit droopy without them).
The second has “support” included as long as you print it upright. Just cut out the two sacrificial layers after it is done.
I printed mine in PETG only because it was already loaded in the printer. PLA would be fine as well. I included 2 files, one with just the bare model which should print just fine. You could probably print it with or without supports (just might be a bit droopy without them).
The second has “support” included as long as you print it upright. Just cut out the two sacrificial layers after it is done.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
